Yes, you can bake a recipe written for a 9x13-inch pan in a 11-inch round pan — but the bake will not behave the same way. The 9x13-inch pan holds about 16.2 cups; the 11-inch round pan holds about 13.2 cups, which is 0.8× as much. Good swap — the volumes are close enough that the bake behaves. Everything below is worked out from those two volumes with the same formula the pan size converter uses, and every figure is approximate, assuming a standard 2-inch depth.
All amounts in this guide are approximate. Pan volumes vary a little by brand and by how the pan is measured, so treat the cup figures as a planning guide and check the bake by look and feel, not by the clock alone.
The volumes, in a table
| Pan | Volume | In cubic inches | Filled two-thirds full |
|---|---|---|---|
| 9x13-inch pan | about 16.2 cups | about 234 cu in | about 10.8 cups |
| 11-inch round pan | about 13.2 cups | about 191 cu in | about 8.8 cups |
The ratio is 0.80×, which is where the rest of this guide comes from. Cubic inches are just the cup figures multiplied by 14.44, the number of cubic inches in one US cup — the same conversion the pan size converter uses. A recipe that makes 16.2 cups of batter, exactly filling the 9x13-inch pan, fills the 11-inch round pan to about 123% of its volume. That is over the two-thirds rule, so do not pour the whole batch in: hold back a cup or two of batter and bake it separately, or scale the recipe down.
How deep the batter sits
A pan swap is really a depth swap. The same batter spreads thinner in a wider pan and deeper in a narrower one, and depth is what decides the baking time. The table below uses the standard 2-inch depth for both pans and the same formula as the pan size converter: round volume is π × radius² × depth, rectangular volume is length × width × depth, and 1 US cup is 14.44 cubic inches.
| Batter in the pan | Depth in the 9x13-inch pan | Depth in the 11-inch round pan |
|---|---|---|
| 4.4 cups | 0.5 in | 0.7 in |
| 6.6 cups | 0.8 in | 1.0 in |
| 8.8 cups | 1.1 in | 1.3 in |
| 16.2 cups | 2.0 in | 2.5 in |
Read the table this way: a recipe that makes 16.2 cups of batter sits about 2.0 inches deep in the 9x13-inch pan and about 2.5 inches deep in the 11-inch round pan. That is a deeper layer, so the middle takes longer to set and the edges can overbake while the centre is still soft — the reason the time table below lengthens the bake. As a rule of thumb, never fill a cake pan more than two-thirds full: for the 11-inch round pan that means no more than about 8.8 cups of batter, and for the 9x13-inch pan no more than about 10.8 cups.
Baking time: how long in the new pan
Baking time does not scale with volume — it scales roughly with the square root of the volume ratio, because heat has to travel through the batter's depth, and depth grows more slowly than volume. That is the rule the pan size converter and the baking time adjuster both use. Multiply the recipe's time by the square root of 0.80, which is about 0.89, and start checking 5–10 minutes before the adjusted time.
| Original time | Adjusted time in the 11-inch round pan |
|---|---|
| 25 minutes | about 22 minutes |
| 30 minutes | about 27 minutes |
| 35 minutes | about 31 minutes |
| 40 minutes | about 36 minutes |
| 45 minutes | about 40 minutes |
| 50 minutes | about 45 minutes |
| 60 minutes | about 54 minutes |
A layer cake that baked for 40 minutes in the 9x13-inch pan needs about 36 minutes in the 11-inch round pan. That is a guide, not a guarantee: ovens run hot and cold, dark pans bake faster than light ones, and a batter with fruit or chocolate holds moisture longer. Start checking at 26 minutes — a skewer in the centre should come out clean or with a few moist crumbs, and the top should spring back when pressed lightly. If the edges are browning too fast, tent the pan loosely with foil and keep baking until the centre sets.
Worked examples
A layer cake for the weekend
A layer cake recipe written for the 9x13-inch pan makes about 16.2 cups of batter and bakes for 40 minutes. Poured into the 11-inch round pan, that batter fills the pan to about 123% of its volume, which is over the two-thirds line — hold back about 7.4 cups of batter and bake it as a small side cake. Set the timer for 36 minutes and check at 31 minutes. The bake will look done at the edges before the middle is set, so trust the skewer, not the colour. Cool in the pan for 10 minutes, then turn out onto a rack: a deeper bake holds heat longer, so it keeps cooking in the pan — get it out on time.
Doubling the batch for a crowd
A double batch makes about 32.4 cups of batter. In the 11-inch round pan that is 245% of the pan's volume — more than the pan can hold, so split it across two pans or bake in two rounds rather than risking an overflow. If you split it, both pans bake at the same time as a single batch, roughly 40 minutes, because each pan holds the same depth of batter as the original. If you pour it all into one pan, the depth doubles and the time grows by roughly the square root of the new ratio — but the edges will be dry long before the centre sets, so splitting is the better bake every time. Use the recipe scaler to work out the doubled ingredient amounts, and remember that leavening does not double with everything else.
When the swap goes wrong
The most common failure in this swap is an overflowing pan or a raw middle. A batter poured too deep into a small pan rises over the rim and drips onto the oven floor, and the centre stays soft while the top burns. The fix is to hold back batter, bake the rest in a second small pan or ramekins, and lower the oven by 25°F (about 15°C) so the heat reaches the middle before the top darkens. Either way, the answer is never to trust the recipe's original time blindly. The time table above is your starting point, and the skewer test is the final word.
How to measure your own pan
The cup figures on this page assume a standard 2-inch depth and a true-to-size pan, and real pans drift from that. The reliable check takes two minutes: put the empty pan on a scale, tare it, and pour in water a cup at a time until the water reaches the rim, counting as you go. The total is the pan's brim-full volume; two-thirds of that is the most batter it should ever hold. If your pan holds noticeably more or less than 13.2 cups, use your measured figure instead of the one on this page — the ratio changes with it, and so does the time. Measuring once and writing the number on a label under the pan saves this whole calculation next time. For more on converting batter and ingredient amounts, see the cups to grams converter.
Practical guidance
Grease and line the 11-inch round pan the way you would the 9x13-inch pan, but pay attention to the corners and edges: a round pan releases best with a parchment circle on the base and a light greasing up the sides. If the recipe calls for a water bath — common for cheesecakes in a springform — the swap needs more care: the new pan changes how the water bath fits, so check the pan sits level and the water comes no higher than halfway up the sides. Oven position matters too: a deeper batter belongs on a lower rack so the top does not brown before the centre sets, and a thinner batter belongs in the middle. Rotate the pan once, halfway through, if your oven has a hot spot — most do.
Frequently asked questions
Can I use a 11-inch round pan instead of a 9x13-inch pan?
Yes, with the adjustments on this page. The 11-inch round pan holds about 13.2 cups against the 9x13-inch pan's 16.2 cups, a ratio of about 0.8×. The batter will be deeper, so bake it for longer and check the centre with a skewer. Do not pour in more batter than two-thirds of the pan — about 8.8 cups — or it will overflow.
How much batter does a 11-inch round pan hold?
About 13.2 cups brim-full, or about 191 cubic inches, assuming the standard 2-inch depth. For baking, the useful number is the two-thirds fill: about 8.8 cups. That is the most batter the pan should hold. The figure is approximate — measure your own pan with water if you want the exact number, because brands vary.
How do I adjust the baking time?
Multiply the recipe's time by the square root of the volume ratio, about 0.89 here. A 40-minute bake becomes about 36 minutes. Then start checking 5–10 minutes before that adjusted time, because ovens vary. The baking time adjuster does the same calculation for any time you enter.
Will the cake taste different in a different pan?
The flavour stays the same, but the texture changes with depth. A deeper layer stays moist in the middle but risks a dense, underbaked centre if you pull it too early. Neither is a failure — it is a different bake from the same batter — but if the texture matters, match the depth as closely as you can, or split the batter across two pans.
What if I do not have either pan?
Look for any pan with a similar volume, not a similar shape. The target is about 13.2 cups at two-thirds fill, so any pan holding roughly 13.2 cups brim-full works with the same time adjustment. The pan size converter compares any two pans by volume, and the pan-size hub lists every pan swap on this site.
Do I need to change the oven temperature?
No — keep the temperature the recipe gives and change the time instead. Lowering the temperature for a deeper batter is sometimes suggested, but it changes the rise and the crust, and it is harder to predict than a time change. The one exception is a very deep batter in a small pan, where dropping the oven by 25°F (about 15°C) and adding time helps the centre catch up without burning the top.